Operator Alerts - Jacobsen HR 9016 Turbo Sicherheits Und Bedienungs Anleitung

3 CONTROLS
3.3

OPERATOR ALERTS_______________________________________________________

The electrical system monitors vital machine systems. It
uses an audible alarm and warning lights to alert the
operator of conditions requiring immediate action. When
an alert occurs follow the general guidelines listed in the
chart below, and any specific actions outlined by the
grounds superintendent or service manager.
To test alarm system:
Turn ignition switch to RUN. Press and hold down alarm
test switch. All warning lights should come on and alarm
should sound.
This system monitors:
1. Hydraulic fluid level
2. Engine oil pressure
3. Engine coolant temperature
4. Hydraulic oil filter
5. Battery voltage
6. Indicates glow plug is energized.
Alert
1. Hydraulic fluid level - Alarm
sounds and hydraulic fluid warning
light comes on. Hydraulic fluid is
below recommended level.
2. Engine Oil Pressure - oil pressure
light comes on. Oil pressure low.
3. Engine Coolant
Alarm sounds. Engine
temperature high.
4. Hydraulic oil filter - Oil filter
warning light remains on.
5. Battery Voltage - Warning light
comes on.
GB-10
Stop tractor immediately, lower decks and shut off engine! Visually
inspect tractor for obvious signs of leaks around connections, hoses and
hydraulic components. Return tractor to service area for maintenance.
CAUTION: Hydraulic fluid is under pressure. Turn engine off and allow
!
fluid to cool before checking fluid level or adding oil to hydraulic tank.
Stop tractor immediately, lower decks and shut off engine! Inspect oil
level in engine. If oil light remains on with oil at proper level, shut off engine
and tow or trailer tractor back to a service area. NEVER operate engine with
oil light on, severe damage to the engine can occur.
Temperature Stop tractor immediately, lower decks and shut off engine! Remove
coolant
debris such as leaves and grass clippings that may be restricting air flow
through rear screen on hood and area between radiator and oil cooler. If
engine continues to run hot, return tractor to a service area.
CAUTION: Engine coolant is under pressure. Turn engine off and allow
!
fluid to cool before checking fluid level or adding coolant to radiator.
Return tractor to a service area as soon as possible. Change hydraulic oil
filters.
Return tractor to a service area as soon as possible. Inspect battery and
battery charging system.
2
5
1
Action
6
4
3
HR003
Figure 3D