Jacobsen HR 9016 Turbo Sicherheits Und Bedienungs Anleitung Seite 11

L. 2WD / 4 WD Switch - Forward
Sets tractor into two or four wheel drive. Tractor must
be in 4WD to operate cutting units.
Tractor returns to 2 WD when backing up unless
4WD reverse switch (Z) is pressed.
M. Engine Throttle
Controls engine speed. Run machine at full throttle
when transporting machine.
N. Throttle Stop
Limits movement of engine throttle lever to lower
PTO for mowing operation. Engage stop to reduce
engine speed when mowing. Disengage stop to run
at full throttle when transporting machine.
Note: For machines sold in Europe, the throttle stop
must be locked in the reduced engine speed position
at all times. Do not tamper with throttle stop lock.
O. Deck Levers
Raises and lowers decks. Decks can be raised or
lowered separately or together. When raising decks
hold lever back until deck is completely up. Levers
return to neutral when released.
P. Down Pressure Control
Transfers weight between decks and tractor.
Turn control clockwise to reduce down
pressure on decks and transfer weight to
tractor. Reducing down pressure improves
traction but may cause decks to float causing an
uneven cut.
To increase down pressure on decks turn
control counterclockwise.
traction but improves deck contact with
ground.
Q. Light Switch (optional)
Controls operation of road and work lights.
R. Warning Lights
Alerts the operator to conditions requiring immediate
action. See Section 3.3.
S. Temperature Gauge
Indicates engine
operating temperature should be between 160° -
230°F (71°-110°C). If temperature rises above 230°
(110°F), alarm will sound. See Section 3.3.
T. Fuel Gauge
Indicates current fuel level. Check fuel gauge daily
before starting machine.
U. Hour Meter
Records engine operating hours. Use hour meter to
schedule periodic maintenance.
This
coolant temperature.
V. Ignition Switch
The ignition switch has three positions. OFF-RUN
(ON)-START. In the run position the electrical system
is active. Turn to START to crank engine. Always turn
switch to OFF and remove key when leaving
machine.
W. Hydraulic Oil Level Light
as a low oil level is detected. The light will come on
momentarily when first starting engine.
X. Cruise Control (Option)
When switched ON the cruise control will lock the
traction pedal in its current position. Cruise will
unlock when switched OFF, or if parking brake is
applied.
Y. Power Take-off Switch
Provides power to cutting units. Tractor must be set in
4WD (L) and decks lowered (O) for cutting units to
engage.
Z. 2WD / 4WD Switch - Reverse
Provides momentary 4WD in reverse
Press and hold switch down to shift into 4WD.
Machine returns to 2 WD when switch is released.
N
reduces
M
L
K
Normal
Z
CONTROLS
Alerts the operator of a low fluid level in
hydraulic tank. See Section 3.3.
Note: The warning light will remain on as long
O
Y X W
3
P
Q
R
S
T
U
V
HR002
Figure 3C
GB-9