Battery Installation; The Settings Can Be Found In This Manual, See - RCM BYTE-Serie Handbuch Für Gebrauch Und Wartung

Squeegee assembly
For packaging reasons the squeegee might have been supplied dismantled from the machine. Assemble the squeegee on the washer-drier
tow plate as follows:
- lower lever 1
- insert pins 2 on the tow plate 3 and tighten the knobs 4
- assemble the suction tube 5 on the squeegee.
Squeegee regulation
For maximised functioning of the squeegee, the back blade "A" must be slightly bent during operation.
In this way liquids are collected by the front side of the blade. Regulate the incline of the squeegee by means of the knob 6, looking for the
best angle with respect to the fl oor (as shown in the fi gure). Regulate as follows:
- clockwise rotation increases incline
- counter-clockwise rotation decreases incline
!
A !
TTENTION
I
F THE BATTERIES TO BE INSTALLED ARE
THE ELECTRONIC CONTROL UNDER THE CONTROL PANEL
FIGURE A".
The batteries are placed in their special bay in the solution tank, which can be accessed by releasing the drainage tube 1 and removing the
recovery tank 3.
Proceed as follows to install batteries:
- verify that the recovery tank is completely empty
- remove the tank
- insert and connect batteries as represented in battery connection diagram 4
- replace the recovery tank and re-attach the drainage tube.
!
A !
TTENTION
C GEL LEAD
HARGING OR
Verify that the recovery tank is completely empty.
Fill the solution tank via the mouth 9 (fi g.1) to deposit clean water at a maximum temperature of 50°C, add diluted liquid cleanser in the
concentration dosage recommended by the manufacturer.
To avoid the formation of excessive foam, we recommend using the minimum amount of suggested cleanser or adding an anti-foam
product.
Always utilise protective gear (gloves, shirts, etc.) when handling detergents or when emptying the tank of recovery liquid.
!
A !
TTENTION
A -
LWAYS USE ANTI FOAM DETERGENTS
D
O NOT USE UNDILUTED ACID
WASHER-DRIER PREPARATION

BATTERY INSTALLATION

GEL LEAD,
OR
( "WASHER-DRIER MAINTENANCE –
BATTERIES SEE
SOLUTION TANK FILLING
, -
USE LOW DANGER DETERGENTS AND REFER TO THE MANUFACTURER INFORMATION SHEET
.
(FIG.2)
(FIG.3)
PERFORM SPECIFIED SETTINGS ON

. "THE SETTINGS CAN BE FOUND IN THIS MANUAL, SEE

ENGLISH ITALIANO
" " 1
DIP SWITCH LOCATED ON
)
CHARGING BATTERIES
.
29 29