BESAFE iZi Twist i-Size Bedienungsanleitung Seite 4

12
Removal of the seat from the vehicle
1. To remove the seat from the vehicle, Twist the seat rearfacing and
push the seat upwards while adjusting the floor support to it's
shortest length.
2. Release the ISOfix connectors out of the seat by pushing down
the switch for the ISOfix connectors on both sides. Pull the ISOfix
release switch on both sides to disconnect from the ISOfix car
anchorage.
Positioning of the child
1. Twist the seat towards the door while you pull the rotation release
handle upwards.
2. Check that the shoulder strap slots are level with your child's
shoulders. (7)
3. While pressing the button of the central adjuster, pull the shoulder
straps away from the seat with a flat hand. Make sure to pull the
straps evenly so that they stay at the same length. (8)
4. Open the harness buckle. (9)
5. The height of the shoulder straps and the head rest can be adjusted
by pulling the release handle upwards at the back of the head rest
and pulling the head rest up or down. (10)
6. Position the shoulder straps over the marking at the sides of
the seat to use the magnets to keep the harness open while you
position the child. (11)
7. When the child is positioned, place the shoulder straps over the
child's shoulders and close the buckle: CLICK! (12)
8. Pull the harness strap through the central adjuster in the direction
of the arrow straight up/forwards. Continue pulling until the
harness is a comfortable but a firm fit. (13)
9. Turn the seat against the driving direction before driving and check
if the release handles show green and the seat is locked into the
driving direction. (14)
Removing and refitting the cover
• Do take care when you remove the cover, as re-fitting the cover is
done in reverse.
• The cover of the head rest can be taken off separately by
disconnecting the beads at the back and pulling off the fabric
towards the front.
! Warning: potential misuse
• The child seat MUST NOT be installed in a front passenger
seat WITH AN ACTIVATED AIRBAG.
• The floor support must always be used. Make sure that the
floor support is fully pushed down and that the seat is positioned
horizontal with the spirit level in the middle.
• Never drive with a child in the seat if the seat is rotated to the side.
• Make sure the indicators are green before you drive.
Guarantee
• Should this product prove faulty within 24 months of purchase due to
materials or manufacturing fault, except covers and harness straps,
please reTwist it to the original place of purchase.
• The guarantee is only valid when you use your seat appropriately and
with care. Please contact your retailer, they will decide if the seat will
be reTwisted to the manufacturer for repair. Replacement or reTwist
cannot be claimed. The guarantee is not extended through repair.
• The guarantee expires: when there is no receipt, when defects are
caused by incorrect and improper use, when defects are caused by
abuse, misuse or negligence.
13