hajdu ZV80Erp Aufbau- Und Betriebsanleitung Seite 23

Really thin walls: hex head bolts (Hungarian Standard M 12, MSZ EN ISO
•
4017), bolt washer for wood connection (M 12). Fixed with 2 U shaped
steels of 60 x 40 x 3 (MSZ EN 10279) vertically at the back side of the
wall.
In case of wall mountable horizontal water tanks, an installation distance of at
least 70 cm has to be guaranteed on the side of the fitting area.
Wall mountable horizontal hot water tanks are delivered in factory adjusted
"left design", mounted ready (see Figure 1)
Check the placement of the suspension legs. If this installation placement is
suitable, then there is nothing left to do, except for mounting the unit on the
bolts fixed on the wall and fix the unit with bolt washers, bolt nuts. Before
mounting the unit, check the tension of the mounting bands, and tighten the
screws fixing the bands placed on the front of the hot water tank, if
necessary.
If the distance between the screws fixed in the wall and the distance of
suspension legs fixed to the unit are different, then the followings should be
done:
1. Loosen the screws fixing the bands (placed on the front of the hot water
tank) and set the bands together with the suspension legs either closer or
farther. Take care that the supporting plate under the suspension legs should
remain under the suspension legs in this new placement, as well.
2. Tighten the screws and lay the hot water tank on a floor being in the same
plane as the suspension legs.
3. Check that the suspension legs remain in the same plane. If you perceive a
different case, then loosen one of the screws. If the suspension legs have
moved in the same plane, then you should tighten the screw again.
4. Mount the hot water tank on the wall according to the above instructions.
In order to install the hot water tank, the following conditions should be
ensured:
-Adequate electricity, pipeline and waste water collection systems should be
ensured on the location of the installation.
-In order to reduce heat loss due to hot water pipe, it is highly recommended
that you install the unit close to locations using hot water. In case of larger
distance between the unit and the location using hot water, is it reasonable to
provide insulation for the hot water pipe.
EN
23