Installation - Ceado E6X Bedienungs- Und Wartungsanleitung

16
11. Always unplug the appliance before performing any maintenance or cleaning and when it is not
in use.
12. Never pull the appliance by the cord to move it. Never unplug it by pulling the cord or touching
it with wet hands.
If the power cable is damaged it must be replaced by the manufacturer or by the
technical assistance service, or at any rate by a person with similar qualifications, so
as to prevent all risks.
13. WARNING: Never place any utensils, metal or other hard materials, in the doser and in the
bean hopper. This is dangerous and could cause damage.
14. Do not use the appliance if it is damaged or has loose parts. Immediately contact an authorized
Service Center.
The appliance complies with European regulation CE 1935/2004 and subsequent updates.
Note: Due to statistical tests on the product in the factory, some coffee grounds may be found in the appliance.
The EC declaration of conformity for this appliance is available in the Products section of our
website www.ceado.com.

INSTALLATION

Comply with the safety recommendations indicated above and hereafter when installing the
appliance.
For the installation of the appliance, qualified personnel must be present who are able to check the
fineness of the grind.
1. Make sure that the mains voltage is as indicated on the rating label of the appliance and that
the electrical system is grounded and equipped with a switch.
2. Install the appliance in a DRY, PROTECTED place, far from water sprays or splashes, heat
sources, open flames and inflammable substances.
Place the appliance on a flat, horizontal, stable surface where it cannot tip over.
3. Put the tray under the doser to keep the work area as clean as possible.
Before connecting the plug to the power socket, make sure that the ON-OFF switch
(9 Fig. 2) is in position "0" (OFF).
4. Plug the power cable into a socket protected by a suitably rated circuit breaker (MCB) or fuses.
Do not use an adaptor plug.
5. Stretch the power cable out to full length. Do not let it pass over sharp edges or hot surfaces.
Do not let oil spill on it. Do not let the power cable hang loose from the counter on which the
appliance stands.
6. Make sure that the bean hopper is correctly positioned and that its shutter is open (8 Fig. 4).
7. To fit the coffee press, if provided, see the enclosed illustrated leaflet.
SAVE THESE INSTRUCTIONS!
GB