Peavey Escort 6000 Bedienungsanleitung Seite 22

Connecting a Powered Sub-Woofer
The Escort 6000 features a Sub-Woofer output that is internally crossed over at
®
100Hz. This output is line level so it will need to be connected to a POWERED Sub or
Escort and your Sub-Woofer is turned OFF. Insert a 1/4" shielded cable into the Sub-Woofer
Output (Fig.5) on the back of the Escort, then insert the other end of the cable into
Connecting a Monitor
The Escort 6000 includes a full-range line level Monitor output. This is to be used
when monitors are required for a performance. This output is line level so you will
monitors. Be sure the power to your Escort and your Monitors is turned OFF. Insert a
1/4" shielded cable into the Monitor Output on the back of your Escort (Fig.6), then insert the
This output can also be sent to another mixer or recording device to record the full-
range signal from your performance. The level of the monitor mix can be controlled by
the master monitor control (Fig. 6a).
Connecting Microphone(s) or Line Input(s)
The Escort's powered mixer is designed to work with any good-quality, balanced, dynamic or condenser microphone such as Peavey's PV i
®
series of microphones. Connect the microphone to the XLR (three-pin) input connector as shown (Fig.7). If using multiple microphones, connect
them in the order they will be on stage for easy adjustment to each microphone. To connect a line level device such as a keyboard, use a 1/4"
instrument cable and insert into the center of the XLR-1/4" combo connector as shown (Fig.8).
Fig. 8
Fig. 7