Change Transmitter From Mode 2 To Mode 1 - Carson Lynx Betriebsanleitung

d. Change Transmitter From Mode 2 to Mode 1
1
GB
Open the cover of the transmitter by unscrewing the 4 screws as the
picture shows.
3
Important: Lift the arm and insert screw a from the left side.
Hold down the ENT key for 1 second to enter the setting status. Press
the ENT key to enter the reverse setting status. Move the arrow to
"Mode" by the up/down key. Shake the stick from up to down by 6
times, Mode 2 will change to Mode 1 automatocally.
Press the EXT key to confirm and exit. Power on again, then it works.
30 CARSON FPV Spy Beast Lynx • 50 050 7053
2
b
a
c
Unscrew a, b and c screws and move screw b, c and the spring to the
other side and fix it. Please test afterwards, if the stick is movable
smooth or not.
4
At the end close the cover again with the 4 screws. Pay attention that
no cable will be squeezed.
b
a
c