Operation; Control And Display Elements - Grundfos Conex DIS-D Montage- Und Betriebsanleitung

9. Operation

9.1 Control and display elements

1
2
3
4
5
Fig. 13 Control and display elements
LEDs
Pos. Description
Alarm: The alarm LED flashes with fault or
1
incorrect input.
Meas: The measuring mode LED
2
illuminates when measurement is active.
Stop: The controller stop LED illuminates
3 when a configured controller is switched
off.
SP: The controller setpoint LED illuminates
if a current limit or setpoint is displayed,
4
and flashes if the SP menu is open in order
to modify the limit or setpoint.
Code: The code LED illuminates when the
5 code menu is selected and flashes when
the code menu is open.
Cal: The calibration mode LED illuminates
6
during calibration.
7 8
Input buttons
Pos.
10
11
9
Description
[Up]:
7 • Increases values.
• Switches between the menus.
[Down]:
8 • Decreases values.
• Switches between the menus.
[OK]:
9 - Enters the desired selection menu.
- Confirms selected value.
[Cal]:
The button switches between calibration
and measuring modes.
Display
• Display of measured value with physical
dimension
• Display of codes and adjustment values
for instrument operation
• Display of alarm events.
11
10
6
15