Austro Flamm Clou Pellet Bedienungsanleitung Seite 21

OPERATING MANUAL
ALERTS and ERRORS
RESET BUTTON
Display of Errors
Your CLOU PELLET does show Errors very
visible and plain with COLOR CODES. (See
COLOR CODES OVERVIEW Page 12 – 14).
Any Error does stop the stove from operati-
on. And the flame on the top right side does
light red. Depending on the character of the
error one or more Performance Stages are
colored by light. By the color of this light you
will know the reason for the error. After the
error is solved you have to delete the ER-
ROR. Therefore move the TURNING KNOB
frantle 3:00 o´clock position speedy clockwi-
se to any performance stage and back to the
3:00 o´clock position.
Display of Alerts
Your CLOU does inform you about FUNCTI-
ON ALERTS. If an Alert shows up the Flame
on the Top right side will lighten permanent
yellow. In addition – based of the kind of alert
– one or more PERFORMANCE STAGES will
lighten colored (See ALERT OVERVIEW Page
10 – 11). Any Alert has to be followed up
and cleared. For deleting an Alert you have
to push the RESET BUTTON short. To get
acces to the RESET KNOB you have to lift
ENGLISH
RESET BUTTON – Acess when
the Hopper Lid is open.
the HOPPER LID (See Picture). If an ALERT
shows up – the stove will stay in operation.
Reset Button
The RESET BUTTON is accessible after the
Hopper Lid is lifted. You do need this BUT-
TON for MANUAL FEEDING and DELETING
ALERTS.
MANUAL FEEDING is requisite before the
FIRST START and after any CLEANING of
the AUGE SHAFT.
IMPORTANT
To get the FUNCTION MANUAL FEEDING
you have to push the RESET BUTTON per-
manent. After 3 seconds the Auger will start
to turn. The AUGER will turn as long as you
push this button. You do have a time frame
of 255 seconds for MANUAL FEEDING. After
255 seconds the alert A006 will show up. To
prevent getting this error close the hopper
lid before 255 seconds. And start feeding
manual again (if the Auger Shaft is completly
empty, it twill take approx. 3 – 4 Minutes to
get Pellets dropping down into the Burn Pot).
21