Inhaltsverzeichnis
Werbung
Product Description
6
Product Description
Read the following information to familiarize yourself with the AXIS 2400/2401, making
particular note of where the connectors and indicators are located.
AXIS 2400 Front Panel
Status Indicator
The multi-colored status indicator shows
the operational status of the server, as
described below:
•
green - the indicator flashes briefly
and momentarily displays orange
during the start-up and self-test
routines; the indicator then displays
green to indicate a healthy unit sta-
tus.
•
red - the indicator will display red
only if a problem with the AXIS
2400 has occurred
•
orange - flashes orange when reset-
ting the factory default settings.
Power Indicator
The Power indicator is normally lit while
power is applied. If it is not lit, or it
flashes, there is a problem with the AXIS
2400 external power source.
Serial Number
Located on the underside label of the AXIS
2400, the serial number is identical to the
Ethernet address of the unit.
Network Indicator
After completion of the startup
and self test routines, the
multi-colored Network Indicator
flashes independently, as fol-
lows:
•
•
•
AXIS 2400 Video Server
VIDEO 1
AXIS 2400/2401 Admin Manual
yellow - indicating net-
work activity on a 10Mbps
Ethernet network
green - indicating network
activity on a 100Mbps Fast
Ethernet network
red - indicating no physical
connection to the network.
VIDEO 2
VIDEO 3
1 2 3 4
75
ON
Control Button
This button is recessed within the product cas-
ing. Using a suitably pointed object, press this
button to restore the factory default settings,
as described in Network Settings, on page 20.
Video Inputs
Accommodates up to 4 separate video sources
(VIDEO 1- VIDEO 4) simultaneously.
Each supported video input is terminated using a
coax/BNC connector. Physical connections made
using RG59, 75 Ohm coax video cable; have a rec-
ommended maximum length of 800 feet (250
meters).
DIP Switches
A corresponding line termination
switch for each of the supported
video outputs. All units are
shipped with the line termination
enabled for each supported video
input; that is, with the DIP
switches set in the down-position.
If the AXIS 2400 is to be con-
nected in parallel with other
equipment, disable the input ter-
mination by turning the corre-
sponding DIP switch to the
up-position (OFF). Failure to do
this can cause the picture quality
to be impaired.
VIDEO 4
http://www.axis.com
Werbung
Inhaltsverzeichnis
