Before Use; Inserting / Replacing Batteries (Transmitter); Inserting / Replacing Batteries (Receiver); Connecting The Temperature Sensor - FLORABEST HG02064 Bedienungs- Und Sicherheitshinweise

When inserting ensure the correct
polarity! This is shown inside the
battery compartment!
Clean the contacts on the battery
and in the battery compartment
before inserting!
Remove exhausted batteries /
rechargeable batteries from the
product immediately.

Before use

R emove all packaging material.
Inserting / replacing batteries
(Transmitter)
E nsure that the product is switched off before
inserting / replacing the batteries.
R emove the hook-and-loop fastener
battery compartment cover
O pen the battery compartment cover
ing the slide fastener in the direction of the arrow.
Insert two 1.5 V
compartment
This is indicated on the inside of the battery com-
partment
R eattach the battery compartment cover
battery compartment
click audibly.
Inserting / replacing batteries
(Receiver)
E nsure that the product is switched off before
inserting / replacing the batteries.
P lace the receiver
fastening clip
S lide the battery compartment cover
pressing down on it gently.
Insert two 1.5 V
compartment
This is indicated on the inside of the battery com-
partment
P lace the battery compartment cover
the battery compartment
ing clip
9
snaps into place.
Connecting the temperature
sensor
Insert the connector
into the socket
14
ter . The temperature sensor
13
in the holder above the transmitter
AAA batteries into the battery
. Ensure correct polarity (+ and -).
18
.
18
18
on its front and remove the
1
by sliding it to the left.
9
AAA batteries into the battery
. Ensure correct polarity (+ and -).
10
.
10
by sliding it into the bracket until it
15
on the side of the transmit-
16
21
.
20
. Please note that it will
and insert the fasten-
10
of the temperature sensor
may be kept
14
13
behind the
by push-
20
to the
20
off while
8
back onto
8
.
GB 11