Fm Radio Operation (Fm); Storing Stations Automatically; Manual Station Scan - Silvercrest SRH 5 A1 Bedienungsanleitung Und Sicherheitshinweise

FM radio operation (FM)

Automatic scan search (AMS)
♦ This device must be switched on. If necessary, briefly press the
switch on the device.
If necessary, briefly press SOURCE /
♦
mode and the frequency display in MHz is shown on the display
Briefly press the VOLUME |
♦
matic station scan. The display
station scan stops at the next station with a sufficiently strong signal.

Storing stations automatically

The automatic station scan with station saving scans the entire frequency band
once and automatically saves the FM radio stations found as an FM station list.
Press the VOLUME |
♦
to start the automatic station scan with station presetting. The display
now shows the message Scanning... FM and the number of found stations.
The scan progress is displayed as a progress bar. The FM radio stations
found are automatically stored in the station list on order of increasing
frequency. When the scan is finished, the first station in the station list is
automatically played back.
NOTE
► The automatic station scan replaces the stations already stored in the preset
spaces.
Selecting stations
Press PRESET
♦
Press TUNE+
♦
station list.

Manual station scan

Press the TUNE+ button
♦
ble station with a higher frequency.
Press the TUNE− button
♦
ble station with a lower frequency.
NOTE
► The frequency of the station is shown on the display
is switched off during station search.
SRH 5 A1
ENTER / SCAN dial
1
now shows the message Scanning.... The
ENTER / SCAN dial
5
for about 2 seconds to call up the FM station list.
8 7
or TUNE−
to select an FM radio station from the
8
for around 2 seconds to jump to the next availa-
7
for around 2 seconds to jump to the next availa-
3
several times until FM radio
6
to start the auto-
6
for approx. 2 seconds
1
and the speaker
GB │ IE │ NI
2
button to
1.
1
9
│ 13 ■