Electrical Connections - Hertz HSC serie Bedienungshandbuch

2.3 ELECTRICAL CONNECTIONS

Ensure that the electrical installation of your compressor is performed by a qualified electrician.
In the enclosed number 3 booklet; your compressor's electrical wiring diagrams, installation
figures and parts list are included
Your compressor is designed to operate with three phase system. The voltage and frequency data are
written on the template of your compressor and in the "Technical data" part of this handbook. Suitable
cross sections for power cable selection are shown in "3.2 Energy cable dimension" section.
Your compressor is designed to operate in + 2 to + 40 °C ambient temperature and at most 1000
meters above the sea level. At higher altitudes, some corrections must be made by taking into account
of environmental conditions. The data related with this is shown in detail at the chapter 6.
(MAINTENANCE) "motor maintenance" of this handbook.
Attach the grounding cable to the outer side of compressor with a screw marked with
the grounding line operates properly.
Working without grounding may be dangerous for the work safety of the personnel and
compressor. In case of failure and critical situation, please properly install your grounding line
in order to prevent death
2.4 START UP (COMMISSIONING)
After implementing energy and air supply installation of the compressor contact our service for start up
procedure. Our service will perform the general inspections, start up the compressor and supply you
beneficial information related with your compressor and its maintenance. If you want to start up the
compressor by yourself read very carefully the chapter 5. (OPERATION) of this handbook. Performing
an erroneous process may be hazardous for the personnel working around.
36
Ensure that
.