Installing The Appliance; Start-Up And Operation - Centrostyle 05444 Gebrauchs- Und Wartungshandbuch

ULTRA_55.qxd 5-11-2004

INSTALLING THE APPLIANCE

• Position the appliance on a stable, level surface.
Leave a gap of 30 cm to either side to ensure easy access to the power socket
in case the appliance has to be rapidly disconnected from the mains.
• Ambient operating conditions:
Temperature: 5°- 40° C. Humidity: < 80%. Avoid dusty atmospheres.
• The mains electricity supply to which the appliance is connected must
conform to applicable standards for the country of installation.
• After intensive use, fumes from the detergent solution may escape from the
cleaner. For this reason always ensure that the working environment has
natural ventilation to the outside.

START-UP AND OPERATION

• Open the cover and place the object to be cleaned in the basket inside the cleaner,
then fill the cleaner with water up to the mark on the tank.
• In the case of Model no. 05546, make sure that the water comes at least to the MIN.
mark, equivalent to a volume of about 300 ml.
• In the case of Model no. 05446, add 2 to 4
capfuls of Centro Style Active Liquid detergent.
With Model no. 05444 1 or 2 are enough.
• Close the cover. Insert the plug in the mains
power socket, making sure first that the mains
voltage corresponds to that specified on the
data plate underneath the appliance.
• The numeric display ³ lights up.
• Set the required cleaning time by pressing the
key .
The display ³ reads out the 5 available cleaning
programs: 90-180-280-380-480 seconds.
• Press the ON key » to start the cleaning cycle.
The red LED · comes on.
• At the end of the set cleaning cycle, the cleaner
switches off automatically and the red LED goes
out.
• Press the OFF key ´ at any time to interrupt the cleaning cycle.
• Repeat the above steps if you wish to perform another cleaning cycle. On completion
of cleaning always rinse the items in clean water.
11:07 Pagina 13
GB
2