Operation With The Plug-In Mains Adapter - Silvercrest SHBS 1000 A1 Bedienungs- Und Sicherheitshinweise

Before first use
The device is fitted with 2 NiMH rechargeable batteries and an
overcharge protection system so that the batteries can be topped up
without being overcharged.
j
C onnect the cable of the plug-in mains adapter to the charging
station of the hair and beard clippers.
5
j
A void injury and damage to the device! Make sure that
the device is switched off before you charge the rechargeable
batteries.
j
I nsert the plug-in mains adapter (wide voltage range 100 - 240 V)
into a mains outlet socket that meets the requirements of the device.
j
T he charge state indicator
red and shows the battery symbol (the symbol indicating that the
device is connected to the mains) and the value indicating the %
of the full charge achieved. After a charge state of approx. 20 %
has been achieved, the charge state indicator
blue and the relevant % value for the charge capacity flashes until
that charge state is achieved. The rechargeable batteries are fully
charged when the 100 % mark stops flashing and is continuously
illuminated.
j
T he charge state indicator
completion of the charging process.
j
T he device can operate with fully charged batteries for up to
about 60 minutes when disconnected from the mains.

Operation with the plug-in mains adapter:

If your hair and beard clippers stop during use because of discharged
or weak rechargeable batteries, you can continue by connecting the
plug-in mains adapter.
14 GB/CY
on the front of the device illuminates
4
switches off a few seconds after
4
changes colour to
4