Honeywell HP-700E Bedienungsanleitung Seite 7

3. Settings panel
The product is on standby and the heating elements
are disconnected
The product functions according to the temperature
chosen on the temperature control
The product functions in ECO mode i.e. according
to the temperature chosen on the temperature
control less 3.5°C
The product functions automatically according to
the room temperature 7°C +/- 3°C.
The product functions according to the input from the
pilot wire or the remote control
4. On/Off switch
This switch activates and deactivates the product and should
only be used if the product will not be used for a longer
period of time. Turning the product off with this switch
results in the loss of internal autonomy and any pre-
programmed information. The product can be set in standby
mode by pressing .
USING THE THERMOSTAT
Comfortable temperature setting:
1. Set the thermostat to maximum until comfortable
temperature has been reached.
2. Move the temperature slider to the left until the pilot light
turns orange.
3. Move the temperature slider a few mms to the right.
If the ambient temperature is above 30°C the product will not
function irrespective of the desired temperature setting.
Similarly if the ambient temperature is below 10°C the product
will function irrespective of the desired temperature setting.
USING THE (OPTIONAL) REMOTE CONTROL
The remote control enables a "comfort" or "eco" temperature
setting and can be programmed independently for every hour of
every day.
You can easily switch from the remote control to the pilot wire
and vice-versa.
With just one remote it is possible to programme several heaters.
All details about programming are included in the instruction
manual of the remote control. Remote control sold separately.
CLEANING
We recommend you to clean the appliance twice a year with a
vacuum cleaner.
USING THE PILOT WIRE
The behavior of the product depends on the voltage applied
between the pilot wire and the neutral wire, as shown in the
following table:
ORDER RECEIVED WAVE SHAPE
No Signal
Complete
Alternating Signal
Negative
Alternating Signal
Semiwave
Positive Alternating
Signal Semiwave
Cyclical Emission of
A Complete
Alternating Signal
Tc=300S To=3S
Cyclical Emission of
A Complete
Alternating Signal
Tc=300S To=7S
Note: the STOP input signal on the pilot wire will switch off the
product even if the mode selector is NOT in the "PROG" mode.
DISPOSAL
This symbol on the product or its packaging indicates that
the appliance cannot be treated as normal domestic waste
but must be handed in at a collection point for recycling
electric and electronic appliances.
Your contribution to the correct disposal of this product protects
the environment.
Further information about the recycling of this product can be
obtained from your local town hall, your refuse collection service,
or in the store at which you bought the product. This regulation
is valid only in EU member states.
CONDITION OF PURCHASE
As condition of purchase the purchaser assumes responsibility for
the correct use and care of this KAZ product according to these
user instructions. The purchaser or user must himself or herself
decide when and for how long this KAZ product is in use.
WARNING: IF PROBLEMS ARISE WITH THIS KAZ PRODUCT,
PLEASE OBSERVE THE INSTRUCTIONS IN THE GUARANTEE
CONDITIONS. DO NOT ATTEMPT TO OPEN OR REPAIR THE KAZ
PRODUCT YOURSELF, AS THIS COULD LEAD TO TERMINATION
OF THE GUARANTEE AND CAUSE DAMAGE TO PERSONS AND
PROPERTY.
Technical modifications reserved
HP-701E
HP-700E
230V~50Hz
230V~50Hz
800W 1300W
ENGLISH
HEATING
MODE
TEMPERATURE
Temperature Set
Comfort
By Thermostat
3˚C Lower Than The
ECO Temperature Set
By The Thermostat
Temperature
Maintained At
Frost Watch
Approx. 7˚C
The Appliance Is
Stop
Switched Off
1˚C Lower Than The
Temperature Set
1˚C Reduction
By The Thermostat
2˚C Lower Than The
2˚C Reduction
Temperature Set
By The Thermostat