Dual Scan; Call Tones; Selecting The Call Tone; Sending The Call Tone - Silvercrest PMR SPMR 8000 A1 Bedienungsanleitung Und Serviceinformationen

SilverCrest SPMR 8000 A1

Dual scan

Your PMR will normally receive one channel only (with or without CTCSS or DCS code). The dual scan
function allows the monitoring of a second channel with CTCSS or DCS code.
While dual scan is enabled, your PMR will toggle between the two channels.
To disable this function, select "OF" when choosing the DCM channel.

Call tones

The call tone is an audible signal that alerts other stations that you want to transmit a message. The
SilverCrest SPMR 8000 A1 supports 15 call tones.

Selecting the call tone

Sending the call tone

Briefly press the Call
114 - English
 Press the Menu
flash on the display.
 Press the Up  [9] or Down  [6] button to switch to a different channel.
 Press the Menu
CTCSS selection. Press the Menu
 Press the Up  [9] or Down  [6] button to set a different CTCSS or DCS
code.
 Press the PTT button [11] to confirm the setting and return to idle mode.
 Press the Menu
the display, the number of the current call tone will flash and the call tone can
be heard.
 Press the Up  [9] or Down  [6] button to set a different call tone.
button [4] to send the call tone over the current channel.
button [5] eleven times. The indication "DCM OF" will
button [5] to confirm the selected channel and continue to
button [5] again to go to DCS selection.
button [5] eight times. The indication "CA" will appear on