Electric Wiring To Motor Command For Up-Down Mode; (2 Independent Up-Down Buttons) - cherubini Garda RX Einstellanleitungen

After to have pressed for minimal 2 seconds one of the 4 buttons on the pocket remote
control, this one will be memorized on the step-by-step mode (UP-STOP-DOWN-STOP).
The following buttons will be not memorized and have to be done with previous described
sequence, and could be used to move additional motors.
DELETING ONE BUTTON ON THE POCKET REMOTE CONTROL
The buttons saved may be deleted individually according to the following sequence:
Tn: Already programmed remote control
Tx: Pocket remote control with button to be deleted
+
A B
Tn
To confirm the operation the motor will do a short shunt and the button, which has to be
pressed for minimal 2 second, will be deleted.

ELECTRIC WIRING TO MOTOR COMMAND FOR UP-DOWN MODE

To connect the switch, use only kind of switches with mechanical or electrical interlock, to
prevent to press both buttons at same time.
The motor automatically recognizes the switch-type (with 1 or 2 buttons) and sets the
proper operational mode.
A

(2 independent UP-DOWN buttons)

Switch with mechanical
or electrical interlocking
Tn
37
2
1
3 4
Tx (2 sec)
1 - BROWN
2 - WHITE
3 - BLUE
4 - YELLOW-GREEN