14
www.electrolux.com
9.4 Auto Off function
To decrease the energy consumption, the
Auto Off function turns off automatically
the appliance:
• if the
not pressed in the time of 5 minutes.
• after 5 minutes from the programme
end.
Push the
appliance.
If the appliance is on, some indications
come in to the view on the display.
9.5 Setting a programme
Use the programme dial to set the
programme.
The time to the programme end comes
into the view on the display.
9.6 Options
Together with the programme you can set
1 or more special options.
To activate or deactivate the option push
the applicable button .
When the option is activated the LED
above the button or symbol on the display
comes into the view.
Start/Pause button was
ON/OFF button to turn on the
9.7 Starting a programme
To start the programme:
Push the
Start/Pause button.
The appliance starts and the LED above
the button does not flash but is stable.
9.8 Programme change
To change a programme:
1. Push the
ON/OFF button to turn
off the appliance.
2. Push again the
turn on the appliance.
3. Set a new programme.
9.9 Programme end
Clean the filter and drain the
water container after each
drying cycle. (See chapter
CARE AND CLEANING.)
If the drying cycle is completed, the
symbol
flashes on the display and the
acoustic signal sounds intermittently for 1
minute.
If you do not turn off the
appliance, the crease guard
phase starts. Laundry can be
removed during this phase.
To remove the laundry:
1. Push the
ON/OFF button for 2
seconds to turn off the appliance.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
ON/OFF button to