4.4.4
Deactivating the anti-theft warning
Completely deactivating the anti-theft warning
Observe the following requirement:
•
he anti-theft warning is activated in the dguard
Activating the anti-theft warning",
1. Open the dguard
2. In order to deactivate the alarm fully, click on the selection button
"Alarm function .
he anti-theft warning function remains deactivated even when you
Ö
switch off your motorbike s ignition.
he anti theft warning is acti e an
1. Switch on your motorbike's ignition.
Ö The LED on the dguard
ed. When the LED on the dguard
system is active and the anti-theft warning is deactivated.
4.5 dguard
roadbook
®
You can use the dguard
recorded a tour, the interactive map shows you your route, your speeds
and the altitude data for your tour. You can add comments to your tours
and share them with your friends on social media platforms.
4.5.1
Recording a tour
1. Open the dguard
2. To record a tour, click
Ö The recording bar at the bottom of the screen opens and shows you
your current recording status.
INFO
Your tours are only recorded when the ignition is
switched on. If you start a recording when the ignition is
switched off, the dguard
is switched on before starting data recording.
OPERATING THE dguard
p. 21).
app and navigate to "Anti-theft warning".
®
button flashes slowly and the system is start-
®
button lights up permanently, the
®
app to record your tours in detail. If you have
®
app and click on "dguard
app and click on
®
.
®
app
®
ou woul li e to ri e o
roadbook .
®
system waits until the ignition
SYSTEM
®
(Chapter "4.4.2
23
EN