Bosch CRR 320 Betriebsanleitungen Seite 43

Interpolation
Set a tick for interpolation of a curve by way of the
points. If no tick is set, the individual points are joined
by lines.
Torque limit values
If this option is marked, the torque limit values of the
Preset or of the screwing parameter with which the cur-
ve was plotted are entered in the graph. The OK range
is shown as a green corridor.
Angle limit values
If this option is marked, the angle limit values of the
Preset or of the screwing parameter with which the cur-
ve was plotted are entered in the graph. The OK range
is shown as a green corridor. In combination with the
torque limit value option, the OK range is displayed as a
green window.
Automatic angle scaling
If automatic angle scaling has been activated, the X-axis
range displayed is based on the highest angle value
actually measured. Otherwise the angle limit values set
are used to determine the range displayed.
Print
Prints the current curve view.
Close
Closes the curve window.
23.11 Marking of points
Points on the curve can be marked. As a result of mar-
king, the perpendicular is dropped from the point to
both axes. The measured values are displayed at the
actual point. There are two marking options:
R
Clicking:
$
Click onto the corresponding point in the dra-
wing.
R
Context menu:
$
Select the value pair in the table.
$
Call up the context menu with a right mouse click.
$
Click onto Mark point.
Robert Bosch GmbH
Work schedule editor | CRR 320 | 43
This method can only be used to mark points with a
white background. Points with a white background are
currently being displayed in the graph. Measured values
with a grey background are not being plotted in the
current interval presentation.
23.12 Removal of marks
Marks can be removed again by way of the context
menu of the Values table.
R
Removal of marking for one point:
$
Select the value pair in the table.
$
Call up the context menu with a right mouse click.
$
Click onto Remove point marking.
R
Removal of marking for all points:
$
Call up the context menu with a right mouse click
on the Values table.
$
Click onto Remove all markings.
en
|
0 986 629 502 2015-02-16