Bosch CRR 320 Betriebsanleitungen Seite 37

Date / time
R
Automatic setting:
On opening the setting dialog, the system data are
entered in the Date and Time panels. As long as
there is a tick on
to run. The wrench time is thus always updated to
the system time on storing the settings.
R
Manual setting:
If data other than the system data are to be ente-
red, the first step is to delete the tick on
A manual value with the format HH:mm:ss can then
be entered under Time. To select a date other than
the system date, use the arrow on the date input
box to call up a calendar from which any desired
date can be selected. Manual entry of the date
with the format DD.MM.YY is also possible.
Threshold value
The threshold value indicates the torque as of
which measured values are to be recorded. The
global threshold value which can be set here is
not referenced to the screwing parameters of the
work schedule as a separate threshold value is
assigned to these parameters.
Brightness / contrast
Symbol Function
R Control Up: Increases display brightness
R Control Down: Reduces display brightness
R Control Up: Increases display contrast
R Control Down: Reduces display contrast
i
Changes to the brightness and contrast of the dis-
play are stored immediately and do not have to be
confirmed separately by way of the Memory Button
(item 11).
Work schedule mode
The setting made determines whether the work schedu-
le stored in the wrench is operated in manual or auto-
matic mode.
R
Manual: Once a screwing parameter has been execu-
ted, the next parameter must be selected manually.
Navigation between the parameters is possible.
R
Automatic: Once a screwing parameter has been
executed, the next parameter in the list is selected
automatically. Navigation between the parameters is
not possible.
Robert Bosch GmbH
the system time continues
.
Settings | CRR 320 | 37
Unit
The unit for global use in the wrench can be altered by
way of the setting made. Clicking onto the arrow dis-
plays the units available for selection.
The global unit which can be set here does not apply
to the screwing parameters of the work schedule, as a
separate unit is specified for these.
Key lock / vibrator
Symbol Function
R Tick set: Key lock on wrench is activated
R Tick removed: Key lock on wrench is
deactivated
R Tick set: Wrench vibrator is activated
R Tick removed: Wrench vibrator is deactivated
!
Changes to the status of the vibrator or key lock are
stored immediately by the wrench and do not have
to be confirmed separately with the Memory button
(item 11).
Starting mode
The display shows the modes to which the wrench may
possibly be set after starting. In addition, the wrench
is automatically set to the selected mode on saving the
setting.
In addition to the standard measurement modes, there
is also the option of selecting
starting mode, the wrench automatically selects the
first work schedule parameter on starting.
Language
The language used in the wrench can be selected by
way of the setting made (item 9).
The selection made does not affect the language in
which the program runs.
End window
This closes the setting window. If changes have been
made to the settings and not yet stored, a prompt ap-
pears offering a "Save" option at this point. Click onto
Yes to save the changes or No to reject these.
Save settings
Transfers all the data not immediately set to the
wrench.
en
Work schedule
. In this
|
0 986 629 502 2015-02-16