Changing Batteries; System Prerequisites; Software-Installation - Bosch CRR 320 Betriebsanleitungen

en 34 | CRR 320 | Changing batteries

16. Changing batteries

!
Attention:
Never re-charge batteries.
i
Note: No data are lost on changing batteries.
¶
If replacement takes more than 10 minutes, the
CRR 320 timer must be set again with the aid of the
software.
Use a size 6 Allen key to screw out the hexagon socket
head bolt (Fig. 9, Item 3) at the housing handle end
(Fig. 9, Item 1). Insert new batteries/fully charged
rechargeable batteries (Fig. 9, Item 2) or replace flat
batteries with new batteries or charged rechargeable
batteries.
Make sure the positive post (+) of the batteries/rechar-
geable batteries is always facing forwards
towards the housing.
Fig. 9: Changing batteries
Screw the hexagon socket head bolt (Fig. 9, Item 3)
into the handle end. This switches on the CRR320 and
the start screen is displayed for approx. 5 seconds.
During this period, set down the CRR 320 on a firm,
vibration-free surface.
!
Important: Do not move the CRR320. The CRR320
then switches automatically to calibration mode.
"Peak" mode is displayed after "Calibration OK". The
CRR320 is then ready for operation.
|
0 986 629 502 2015-02-16
17. Software
17.1

System prerequisites

PC with RS 232 serial interface or USB interface
Operating system: MS Windows (Windows 2000 incl.
Service Pack 4, Windows XP incl. Service Pack 2 or
Windows Vista) MS Excel (as of Excel 2000)
17.2 Operating system extensions
required
NET Framework 2.0 or newer MDAC 2.81 (part of ope-
rating system as of Windows XP SP2) Crystal Reports
(only needed for printing the menu/work schedule).
If any of the above mentioned operating system extensi-
ons are not available on your system, this will be recog-
nized automatically during installation.
Provided that an internet link is available, the necessary
files will be loaded from the internet and installed for
the .NET Framework and MDAC 2.81.
If no internet link is available, the corresponding exten-
sions must be installed manually from the CD.
A corresponding driver must be installed for the USB
connection.
17.3 Manual installation of operating sys-
tem extensions required
MDAC (Windows 2000 and Windows XP prior to SP 2
only)
1. Open the Drivers folder from the CD.
2. Open the folder MDAC28.
3. Double click to execute the mdac_type.exe file.
4. Follow the instructions.
NET Framework
1. Open the Drivers folder from the CD.
2. Open the folder .Net Framework.DE.
3. Double click to execute the dotnetfx.exe file.
4. Follow the instructions.
17.4 Software installation
1. Double click onto setup.exe.
2. Any missing operating system extensions are ins-
talled provided that an internet link is available.
3. Confirm the Welcome page with Continue >.
4. Enter the destination folder (Standard folder:
C:\Programme\Bosch\CRR320).
5. Confirm with Continue > until installation has been
completed.
The program can then be started by double clicking
onto the CRR 320 symbol now provided on your Desk-
top.
Robert Bosch GmbH