Bosch CRR 320 Betriebsanleitungen Seite 36

en 36 | CRR 320 | Functions
20. Functions
Once a link has been established with the CRR 320,
various functions can be called up from the main mask.
Fig. 11: Functions
1) Disconnection of link with wrench
2) Opening of work schedule editor
3) Editing of screwing parameter stored as Preset in the wrench
4) Editing of global wrench settings (date, time, unit, starting
mode)
5) Termination of program
6) Transfers the measured values stored on the wrench to the Me-
mory table
7) Irrevocably erases the measured values stored on the wrench in
addition to the curve plots
|
0 986 629 502 2015-02-16
21. Settings
Fig. 12: Settings
1) Functional tests
2) Date / time
3) Threshold value
4) Brightness / contrast
5) Work schedule mode
6) Unit
7) Key lock / vibrator
8) Starting mode
9) Language
10) End window
11) Save settings
12) Auto Off
13) Gauge dimension
14) Auto Reset
Clicking onto the Memory button (11) transfers all
changes to the wrench.
Functional tests
Symbol Function
All LEDs on the wrench light briefly
Brief vibrator response
An acoustic signal is generated
During the functional tests, the user must check whe-
ther the corresponding action is implemented when a
test button is pressed. If this is not the case, the corre-
sponding component may not be functioning properly.
Robert Bosch GmbH