Bosch CRR 320 Betriebsanleitungen Seite 29

9. Torque measurement with
specification of limit valu-
es (Md)
Use the navigation keys
main menu.
In the main menu, select the menu item "Preset" with
the navigation keys or
Confirm selection with the acknowledgement key
Use the navigation keys
item "Md".
Confirm selection with the acknowledgement key
The desired limit values (parameters) can now be pro-
grammed in the CRR 320.
If the existing limit values are to be adopted, each indi-
vidual value must be confirmed with the acknowledge-
ment key .
The following parameters must be set.
Designation Description
Nom. value Nominal value = Target value in Nm
Min. value Minimum value = Lower tolerance limit in Nm
Max. value Maximum value = Upper tolerance limit in Nm
Direction Measurement direction (clock-
wise , counter-clockwise).
Only all the torques in the selected mea-
surement direction are then recorded.
9.1 Programming of limit values Md
Use the navigation keys
main menu.
In the main menu, select the menu item "Preset" with
the navigation keys or
Confirm selection with the acknowledgement key
Use the navigation keys to select the menu item "Md".
Confirm selection with the acknowledgement key
Robert Bosch GmbH
Torque measurement with specification of limit values (Md) | CRR 320 | 29
or to switch to the
.
.
or to select the menu
.
or to switch to the
.
.
.
The navigation keys or
ment or decrement a value or alter the measurement
direction.
The navigation keys or
each position (right or left).
Use the acknowledgement key
The programmed values can be displayed with the navi-
gation keys or .
The navigation keys or
ching to the main menu.
9.2 Programming of limit values Md - Wkl
and Wkl - Md
The following parameters must be set:
Designation Description
Nom. value Nominal value = Target value in Nm
Min. value Minimum value = Lower tolerance limit in Nm
Max. value Maximum value = Upper tolerance limit in Nm
Joining value Starting torque for angle measurement in Nm
Nom.Wkl Nominal angle value = Target angle value in °
Min. Wkl Minimum angle value = Lower tolerance limit in °
Max. Wkl Maximum angle value = Upper tolerance limit in °
Direction Measurement direction (clockwise,
counter-clockwise).
Only all the torques in the selected mea-
surement direction are then recorded.
Use the navigation keys
main menu.
In the main menu, select the menu item "Preset" with
the navigation keys or
Confirm selection with the acknowledgement key
Use the navigation keys
item "Md - Wkl" or "Wkl - Md".
Confirm selection with the acknowledgement key
en
can be used to incre-
can be used to move to
to save the entries.
are required for swit-
or to switch to the
.
.
or to select the menu
.
|
0 986 629 502 2015-02-16