Bosch CRR 320 Betriebsanleitungen Seite 30

en 30 | CRR 320 | Torque measurement with specification of limit values (Md)
The navigation keys or
ment or decrement a value or alter the measurement
direction.
The navigation keys or
each position (right or left).
The programmed values can be displayed with the navi-
gation keys or .
The navigation keys or
ching to the main menu.
|
0 986 629 502 2015-02-16
can be used to incre-
can be used to move to
are required for swit-
10. Menu item: Work schedule
Use the navigation keys
main menu. In the main menu, select the menu item
"Work schedule" with the navigation keys
Confirm selection with the acknowledgement key
Fig. 6: Menu item: Work schedule
The first screwing operation in the work schedule ap-
pears on the display.
Use the navigation keys
screwing parameter ("manual" work schedule only).
The cancel key can be used to switch to the main
menu.
When generating a work schedule with the aid of the
software it is possible to specify whether a work sche-
dule is to be executed "manually" or "automatically".
i
Explanatory notesA work schedule is a collection of
several screwing parameters (e.g. pre-tightening - un-
fastening - finish tightening). These screwing para-
meters contain all the data for a screwing operation
(e.g. min./ max. values, measurement direction,
angle, ...). In this version, the CRR 320 can store a
maximum of 5 screwing parameters in a work sche-
dule.
¶
The screwing parameters can only be programmed
by way of the software contained in the scope of
delivery.
10.1 Manual work schedule
If a "manual" work schedule has been generated and
stored in the CRR 320, it is now possible to use the
navigation keys or
vidual screwing parameters.
Selection of the desired screwing parameter is confir-
med with the acknowledgement key 8.
The programmed values can be displayed with the navi-
gation keys or .
or to switch to the
and
or to switch to the next
to choose between the indi-
Robert Bosch GmbH
.
.