Machine Use - T.O.M GSS13V Originalbetriebsanleitung

MACHINE USE

Read and make sure you have understood the following points concerning your scroll saw before beginning any work with the machine.
N.B. The scroll saw is generally intended for cutting curves.
1.This saw has been designed for cutting wood and non-ferrous metals. Please refer to the section "Optional accessories" to select the
suitable blade for your workpiece.
2.Make sure that the saw teeth are facing downwards for an optimal cut.
4.Press the operating switch then slowly guide the workpiece against the blade; the blade teeth are very small and can only cut
downwards.
5You will obtain the best results if your workpiece is less than 25 mm thick. If the workpiece is thicker than 25 mm, guide it very slowly
towards the blade.
6.For a precise cut, you may have to make up for the movement of the blade, which tends to follow the grain of the wood.
7. Be careful with workpieces of irregular sizes. The piece of wood could get stuck against the blade before it has been completely cut. A
8.Be careful when cutting round pieces of wood, such as beadings or mouldings. These tend to roll during cutting and get stuck in the
blade.
As the blade teeth wear out, they must be replaced frequently for optimal cuts (every 30 minutes of cutting time).
N.B.
For inside cuts, drill a Ø 3 mm hole in the part to be removed, then pass the blade through the hole. It can then be reinstalled.
Speed variation
The variator knob and the operating switch are on the left side of the machine, underneath the table.
To start up the machine, press the button I.
To stop the machine, press the button O.
Turning the variator knob to the left increases the rotation speed, and turning to the
right reduces the rotation speed.
803204
803200
803201
803201
16
700606-Manual-C.indd 16
10 Skip tooth blade, width 25-50 mm,
15 Skip tooth blade, width 25-38 mm,
18 Standard tooth blade, 2-13 mm,
25 Standard tooth blade, 2-13 mm,
hard and soft wood, plastic, etc.
mixed material, MDF, wood, felt, paper, lead
wood, plastics, etc.
wood, plastics, etc.
31/08/15 11:28:26