T.O.M GSS13V Originalbetriebsanleitung Seite 14

SPECIFICATIONS
Motor power
Power supply
Rotation speed
Max. cutting height
Blade length
Table tilt
Throat depth
Weight
Before starting any work on the saw, disconnect the machine from the power supply
Table tilt
Unscrew the knob on the front of the table and tilt the table to the left until it reaches the required angle.
Then tighten the table locking knob.
Place a square on the table as shown below. If the blade and the edge of the square are not parallel,
unscrew the table locking knob and readjust the tilt.
Tighten the table knob and unscrew the screw holding the indicator to adjust it to 0 on the graduated scale.
14
700606-Manual-C.indd 14
Attach the arm to the
motor + table unit using
the 4 assembly screws
provided.
Attach the blade guard
support using the knob. Fit
the blade guard onto its
support as shown in the
photo.
125 W S2 10 min
230 V~50 Hz
Adaptable between 750 and 1500 stroke/
min using an electronic speed
50 mm
127 mm
from 0 to 45 ° to the left
330 mm
11,80 Kg
IMPORTANT!
Blade unlocking knob
Attach the arm to the rear of
the table using the Allen key
provided.
Screw the blower on to the
arm.
Bevel indicator
31/08/15 11:28:25