Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The crossed-out wheeled bin means that within the European Union the product must be taken to separate collection at
the product end-of-life. This applies to your device but also to any accessories marked with this symbol. do not dispose of
these products as unsorted municipal waste.
In accordance with the WEEE directive concerning the environment, it is forbidden to abandon used electric or electronic
equipment or leave them at a standard public dump. The equipment must be taken to a collection point for treatment, re-
covery and recycling of EEE waste, or returned to its dealer on a 1 for 1 basis (one item of equipment bought for one item
of equipment taken back). The user is therefore taking an environmentally-friendly step and helping to preserve natural
resources and protect human health.
EXTENSION CORDS
Only use extension cords with three conductors ending in two-pin plugs and sockets with two holes and an earth pin that are suited to
the plug of the tool. When using a power tool at a considerable distance from the power source, use an extension cord heavy enough
to carry the current that the tool will draw. An undersized extension cord will cause a drop in line voltage, resulting in a loss of power
and causing the motor to overheat. Use the chart provided below to determine the minimum wire size required in an extension cord.
Only round jacketed extension listed by laboratories should be used.
Length of extension cord: up to 15 m
Wire size: 3 x 2.5 mm2
Before using an extension cord, inspect it for loose or exposed wires and cut or worn insulation. Repair or replace any damaged or
worn cord immediately.
ELECTRICAL CONNECTIONS
Your machine has a precision built electric motor. It should be connected to a power supply that is 230 V, 50 Hz. If your tool does not
operate when plugged into a socket, double-check the power supply characteristics.
The noise level of the machine is measured according to standards DIN EN ISO 3744: 1995-11 and DIN EN ISO 11203: 1996-07.
The values given are emission values calculated according to applicable standards and not values relating to use in the workplace.
Although correlation between those different emission levels does exist, this cannot be reliably used to determine whether additional
period of work, the size of the room and any other sources of noise (e.g. number of machines operating, other noisy work being carried
out at the same time). Acceptable exposure levels may vary from one country to another. For all these reasons, we would advise users
to wear equipment to protect their ears while using this machine.
Acoustic pressure level LpA: 79.3 dB (A) Acoustic pressure level LwA: 92.3dB
Uncertainty: 3 dB (A)
damaged. This tool is designed to be used with a circuit containing a power socket. It is also equipped with an earthing pin.
700606-Manual-C.indd 11
ENVIRONMENT PROTECTION
CONNECTING THE MACHINE – ELECTRICAL CONNECTIONS
NOISE INFORMATION
EARTHING INSTRUCTIONS
Earthing consists in connecting metal masses, that are liable to come acciden-
tally in contact with the current due to faulty insulation in an electrical device, to
an earth connection by means of a conductive wire. That earth connection, when
used with a differential circuit breaker, prevents electrical incidents. The current
modify the supplied plug. If it cannot be put into the socket, have an appropriate
incorrectly connected, this can lead to a risk of electric shock. The earth conduc-
tor is contained in green insulation with a yellow line. If the power cord needs to
be repaired or replaced, do not connect the earth conductor to a live terminal.
are not fully understood or if in any doubt about the correct earthing of the tool. If
the power supply cable is damaged, it should be replaced by the manufacturer, the
11
31/08/15 11:28:25
Werbung
Inhaltsverzeichnis
