Fitting The Blade - T.O.M GSS13V Originalbetriebsanleitung

Fitting the blade

Disconnect the machine from the power supply.
The blade may be positioned facing towards the user or towards the side, depending on the size of the workpiece to be cut (see photo
below).
support and insert the blade into this support.
-Release the knob: the blade is correctly tightened through the springs within the body of the machine.
vibrations and noise.
1.Position the scroll saw on the work surface, mark the fastening points of the frame then drill the fastening holes using a Ø 10 mm drill.
2.Screw the scroll saw on to the work surface using bolts, washers and nuts. Be aware that these fastening parts are not provided with the
machine.
We recommend you place a foam pad or a piece of carpet between the saw and the work surface in order to minimise noise and vibrations.
WARNING! machine must be connected to the earth.
-
cian.
WARNING! Avoid all contact with the terminals of the plug while connecting to the power source (and while disconnecting). Any contact
may cause a serious electric shock.
Using an extension cord
Using an extension cord may cause a loss of power. In order to reduce this loss of power as much as possible and to avoid the motor
tool's male plug.
15
700606-Manual-C.indd 15 31/08/15 11:28:25