Assembly/Mounting; Connection - led2work UNILED II 4000-4500 K Betriebsanleitung

3 | Safety information
Only use the device if it is completely free of faults, and with safety
and awareness in mind. If warnings or symbols are attached to the
luminaire, they must not be removed.
4 | Assembly / Mounting
Check the LED luminaire before installation to ensure it is complete and shows no
signs of damage. Do not use the luminaire or accessories if they are damaged, as
there is a risk of injury.
The LED luminaire comes fully assembled. The assembling takes place via the sup-
plied table clamp. Adjustment of the spring tension of the adjustable arm via slotted
screw in the base. Enclosed locking disk allows a fixation of the arm and prevented
simple or unintended pivoting.
As option there are this mounting pieces and accessories:
Wall mount bracket for adjustable arm Luminaire
T-slot bracket for adjustable arm Luminaire
Screw-on base, plastics incl. screws for adjustable arm Luminaire
Fastening plate, aluminium
Magnifier for UNILED II, 3.39dpt.
Universal table clamp (spare part)
When mounting the luminaire, make sure that the luminaire is
fastened securely and stably. If the luminaire falls down, its weight
poses a risk of injury!

5 | Connection

Suitable connection material, cables and accessories can be found in the accessory
range of LED2WORK.
Possible variants of the M12 connector
Operate luminare with power supply unit only! No direct connection to 230V AC!
10 | BA UNILED II . BA 01/2019
Item no.
215100-01
215200-01
215400-01
215400-02
215500-01
215600-01