Assembly/Mounting; Connection - led2work TUBELED 25 Betriebsanleitung

4 | Assembly / Mounting
Check the LED light before installation to ensure it is complete and shows no signs of damage. Do not use the light or
accessories if they are damaged, as there is a risk of injury.
The LED light comes fully assembled. The light is intended for mounting in optional mounting angles. As option there are
this mounting accessories:
TUBELED_25 light bracket, VA, 1 pair, light adjustable 60°
TUBELED_25 light bracket, VA, 1 pair, light adjustable 60°, with magnet
TUBELED_25 light bracket, VA, 1 pair, light adjustable 180°
TUBELED_25 light bracket, VA, 1 pair, light adjustable 180°, with magnet

5 | Connection

Suitable connection material, cables and accessories can be found in the accessory range of LED2WORK.
PIN assignment of the M8 connector is as follows:
PIN assignment
PIN 1 = 24V DC
PIN 3 = GND
PIN 4 = not used
10 | BA TUBELED_25 . BA 08/2023
When mounting the light, make sure that the luminaire is fastened securely and stably. If
the luminaire falls down, its weight poses a risk of injury!
Schematic drawing of M8 plug
Through-wiring (cascadable): Via through-wiring (cascadable) allows the electrical
connection of several lights provided for this purpose.
Cascadable: The total current consumption must not exceed 4 A DC at ta +40°C max.
The light is not equipped with a ON/OFF switch. Usually you switch the light ON or OFF
via external switches of machines or systems.
Lights with cascading capability output +24V DC at PIN 1 and GND at PIN 3 of the output
socket.
Product no.
210200-23
210200-24
210200-25
210200-26