Pin Allocation; Maintenance And Care; Warranty - led2work UNILED II 4000-4500 K Betriebsanleitung

UNILED II
PIN assignment of the M12 connector is as follows:
4
1
Schematic drawing of M12 plug
PIN 3 = 0V DC. 24V DC for supply can be connected to PIN1 or PIN 4.
It is not necessary to assign both PINs (PIN 1 and PIN 4) at once!

6 | Maintenance and Care

The LED luminaire is maintenance-free. Do not make any alterations to the luminaire
(except according to the mounting information contained in this manual). Do not open
the luminaire! Repairs by the manufacturer only. The luminants used in the luminaire
have a very long life and cannot be replaced.
Turn off the light before cleaning and let it cool down completely. Clean the outside of
the luminaire with a soft, dry and clean cloth. To remove excess dirt, moisten the cloth
with water. Never use aggressive cleaning agents, as these may cause discolouration
of the housing.

7 | Warranty

We supply a full warranty for the product for 36 months from the date of purchase. This
warranty applies for fault-free working under proper use and in accordance with the
operating instructions.
During the warranty period defects and faults in the product will be rectified free of
charge if they are proven to be caused by material, processing or design errors. If the
purchaser complains of a material defect, he bears the burden of proof to demonstrate
that the product was already defective upon receipt.
The warranty does not extend to defects caused by wear, negligen-
ce or improper use.
Further claims, in particular claims for compensation for damage
that did not occur on the LED luminaire itself, are excluded.
3
5
2
No liability is assumed for damages resulting from the use of unsuit-
able cleaning agents.

PIN allocation

PIN 1 = 24V DC
PIN 2 = not used
PIN 3 = GND, 0V DC
PIN 4 = 24V DC
PIN 5 = not used
| 11