Assembly/Mounting; Connection - led2work UNILED SL 230V AC Betriebsanleitung

4 | Assembly / Mounting
Check the LED luminaire before installation to ensure it is complete and shows no
signs of damage. Do not use the luminaire or accessories if they are damaged, as
there is a risk of injury.
The LED luminaire comes fully assembled. The assembling of the luminaire takes
place by M8-screws via the boreholes at the luminaire housing.
As option there are this mounting pieces (except version adjustable drawbar):
UNILED SL wall angle bracket (pair)
UNILED SL angle bracket (pair)
When mounting the luminaire, make sure that the luminaire is
fastened securely and stably. If the luminaire falls down, its weight
poses a risk of injury!

5 | Connection

UNILED SL 230V AC - item numbers 110914-3x and 110914-4x:
luminaire is connected with a 230V AC electric power supply system via the M12 plug
S-coded.
1
chematic drawing of M12 plug S coded
UNILED SL 230V AC - item numbers 110914-5x and 110914-6x:
The luminaire is connected with a 230V AC electric power supply system via the cable
with SCHUKO plug.
UNILED SL 230V AC - item numbers 110914-7x and 110914-8x:
UNILED SL with adjustable drawbar is a suspended luminaire and
needs a handover point at the ceiling. The connection point to
230V AC is under the canocopy on the side with the switch. Before
connection the luminaire have to hang on the cable reels of the
two adjustable drawbars.
10 | BA UNILED SL 230V AC . BA 03/2020
3
2
PIN allocation
PIN 1 = brown, N.C.
PIN 2 = black, L
PIN 3 = gray. N
PIN 4 = yellow/green. PE
Item no.
213200-01
213200-02