Privacy Zone Setting [Privacy Zone] - Panasonic WV-CLR930 Bedienungsanleitung

12. Privacy zone setting [PRIVACY ZONE]

When undesired portions in the camera shooting area (on the screen) exist, those portions (pri-
vacy zone) are hidden.
ON (1): Grays the zone.
ON (2): Mosaics the zone.
OFF (default): Displays the zone normally.
Up to 8 portions can be specified for the privacy zone. Follow the procedure below for privacy
zone setting.
Note:
• The privacy zone function is disabled at initializing the unit, i.e. right after turning on the
power.
"CAMERA SETUP" screen
**CAMERA SETUP** 2/2
PRIVACY ZONE OFF
MIRROR OFF
LENS-DRIVE DC
STABILIZER OFF
RET TOP END
Step 1
Move the cursor to "PRIVACY ZONE", select
"ON (1)" or "ON (2)", and press the setting
button.
→ The zone number selection screen
appears.
Step 2
Use the right or left button to select the target
zone number after ascertaining that the cur-
sor is present on "1" of "1/8" located at the
right side of "ZONE NUMBER". When a zone
number is marked with "*" at its right side, the
zone with the number is already set to the
privacy zone.
Zone number selection screen
**ZONE NUMBER 1 /8**
RET TOP END
Step 3
Press the setting button after zone number
selection.
→ The zone setting screen appears.
Notes:
• When a zone number that is already set
• To cancel the zone setting, move the cur-
Zone setting screen
**ZONE NUMBER 1 /8**
POSITION
SCALE
SET DEL
RET TOP END
to the privacy zone in Step 3 is selected,
the image of the zone is displayed in the
zone frame on the zone setting screen.
Performing Step 4 and Step 5 clears the
setting zone and implements new zone
setting.
sor to "DEL" and press the setting button.
The zone setting is canceled.
→PUSH SW
→PUSH SW
45