Panasonic WV-CLR930 Bedienungsanleitung Seite 41

Advanced settings about motion detector function (MODE1)
The description below specifies the sensitivity level and detection area of the motion detector
(MODE1).
To perform mask setting, set the image stabilizer, i.e. "STABILIZER" to "OFF". ( page 47)
"CAMERA SETUP" screen
**CAMERA SETUP** 1/2
CAMERA ID
ALC/ELC
SHUTTER
AGC
SENS UP
SYNC
WHITE BAL
MOTION DET
DNR
RESOLUTION
O
BW MODE
"MODE 1" screen
**MODE1**
LEVEL
DWELL TIME
DISPLAY MODE
ALARM
O
MASK SET
RET TOP END
Mask setting screen
O
OFF
O
ALC
OFF
O
ON
OFF
INT
O
ATW1
OFF
HIGH
HIGH
···I···255
- +
2S
O
OFF
Step 1
Set "MOTION DET" to "MODE1" and press the
setting button.
→ The "MODE1" screen appears.
Step 2
Move the cursor to "MASK SET" and press
the setting button.
→ The mask setting screen appears.
Step 3
Perform mask setting. The operation proce-
dure is the same as the masking operation in
the process of "Sensing area setting for
backlight compensation". ( page 30)
Step 4
Hold down the setting button for approx.
more than 2 seconds after completion of
masking.
→ The "MODE1" screen appears again.
Step 5
Move the cursor to "ALARM", and decide
whether or not to provide an alarm signal in
the demonstration mode with use of "ON" or
"OFF".
ON: Provides an alarm signal output in the
demonstration mode, and allows users to
check the operation on the monitor when
a motion is detection.
OFF (default): Provides no alarm signal out-
put in the demonstration mode.
41