Sure Microchip Pet Feeder Connect Bedienungsanleitung Seite 27

The Hub
Red flashing ears
Your Hub has lost connection with the Microchip Pet Feeder Connect.
• If you are seeing both ears flashing red during setup, please perform a factory reset by
pressing the button on the base of your Hub for 10 seconds.
• If you are seeing both ears flashing red for prolonged periods after setup, try power
cycling your Hub. Switch the power off at the socket, leave it for 30 seconds, and then
turn it back on. If the ears remain solid green for a few minutes, the Hub has reconnected.
• You can also try relocating your Hub following the advice given on page 9. If that
doesn't work, you will need to move your Hub closer to the Feeder - read below.
• In order to move your Hub closer try connecting it to your router using a longer Ethernet
cable.
• If the above doesn't work, we recommend purchasing an 'Ethernet over power
adapter'. This will plug into a normal power socket and allow you to connect your Hub to
the internet closer to your feeder.
Alternating flashing ears (red or green)
Your Hub is having problems connecting to the Sure Petcare servers. This could be because
of an unreliable internet connection.
• Try power cycling your Hub by switching the power off at the socket, leaving it for 30
seconds, and then turning it back on. If the ears remain solid green for a few minutes, the
Hub has reconnected.
• If the above doesn't work, make sure your internet router is turned on and that your
internet connection is working correctly with other devices.
• If it isn't working with other devices, try switching your router off, leaving it for 30
seconds, and then turning it back on.
• If your router is working with other devices, try re-connecting the Ethernet cable into
the router and the Hub. Make sure it is pushed in all the way, as it can appear connected
when it isn't.
If you keep having connectivity issues please visit: surepetcare.com/hub-connectivity
Solid red ears
Your Hub is undergoing a firmware update. Be patient and wait for the Hub ears to turn
green. This shouldn't take longer than 2 minutes. Once the firmware update is complete the
Hub will need to reboot. At this point you will see the setup light sequence - see page 10.
Slow notifications
If you find some messages are slow to appear on your app, this is likely because your Hub
is having to work hard to connect to your Microchip Pet Feeder Connect. To improve the
speed of messages, try moving your Hub to a better location following the advice given on
page 9.
EN
26