Installing On A Network - Axis 2420 Bedienungsanleitung

Installing on a Network

12
Installing on a Network
• Macintosh users - Please refer to Notes for Macintosh Users, on page 53.
• Easy installation - Use The AXIS IP Installer. See Using the AXIS IP Installer, on page 52.
• Quick installation - Follow the instructions below to install the AXIS 2420 on an Ethernet network.
Fit or replace a lens (if required). The lens is fitted by
turning it in a clockwise direction.
Note the Serial number on the underside of the
unit. You need to know this to set the IP address.
Using an appropriate method for your operating system, assign your product with a unique IP
address from a computer on your network, as follows:
Windows only - Start a DOS window and type in the commands
shown below:
Syntax:
arp -s <Camera IP address> <Ethernet address> <my PC IP address>
ping -t <Camera IP address>
Example:
arp -s 172.21.1.200 00-40-8c-10-00-86 172.21.1.193
ping -t 172.21.1.200
Note:
In some Unix systems, the arp command can be located in a directory that is not on the
command path.
You will now see '
Request timed out...
Connect an Ethernet cable to your AXIS
2420 and attach it to the network.
AXIS 2420 User's Manual
UNIX only - Type these commands in the command
window:
Syntax:
arp -s <IP address> <Ethernet address> temp
ping <IP address>
Example:
arp -s 172.21.1.200 00:40:8c:10:00:86 temp
ping 172.21.1.200
' messages repeatedly returned in the window.
Serial number same as
Ethernet address; e.g.
00408c100086 =
00-40-8c-10-00-86
Network Connector
RJ-45 Connector