Network Connector; Control Button - Axis M3014 Installationsanleitung

• The Status LED can be configured to flash for identifying the unit. Go to Setup > System
Options > Maintenance .
Status LED
Green
Amber
Red
Network LED
Green
Amber
Unlit
Power LED
Green
Amber

Network Connector

RJ45 Ethernet connector with Power over Ethernet (PoE).
NO TICE NO NO TICE TICE
Due to local regulations or the environmental and electrical conditions in which the product
is to be used, a shielded network cable (STP) may be appropriate or required. All cables
connecting the product to the network and that are routed outdoors or in demanding
electrical environments shall be intended for their specific use. Make sure that the network
devices are installed in accordance with the manufacturer's instructions. For information
about regulatory requirements, see Electromagnetic Compatibility (EMC) on page 2 .

Control Button

For location of the control button, see Hardware Overview on page 8 .
The control button is used for:
• Resetting the product to factory default settings. See page 13.
• Connecting to an AXIS Video Hosting System service or AXIS Internet Dynamic DNS
Service. For more information about these services, see the User Manual.
AXIS M3014 Network Camera
Indication
Steady green for normal operation.
Steady during startup. Flashes when restoring settings.
Flashes red for firmware upgrade failure.
Indication
Steady for connection to a 100 Mbit/s network. Flashes for
network activity.
Steady for connection to a 10 Mbit/s network. Flashes for
network activity.
No network connection.
Indication
Normal operation.
Flashes green/amber during firmware upgrade.
9