On/Off Switch; Operation - Klarstein BellaVita Espresso 10033137 Bedienungsanleitung

1 Top cover
2 Rotating knob
3 Espresso button (single cup)
4 Espresso button (double cup)
5 Steam button
6 Front panel
7 Porta-filter:
7-1. Single cup filter
7-2. Double cup filter
7-3. Retention clip
7-4. Filter holder

OPERATION

Before first use
1 Make sure that the water tank is filled with water till max mark.
2 Place a cup right onto cup tray.
3 Plug on and turn on the machine. The buttons on the control panel will flash red and
blue by turns.
4 Press any button, the unit will start pumping a small amount of water. Wait till the
water finishes, then the unit will enter to pre-heating mode.
Espresso
1 Plug the unit in. Switch on the unit.
2 Rotate the knob to the "0" position to start the preheating. The coffee and steam
button will keep flashing during preheating. Lights will stop flashing and remain on
steadily while finishing preheating.
Note: The unit will dispense a small amount of water to the drip tray, when the
machine is finished the coffee brewing or steam making and the knob is rotated to
middle position. This is normal.
8 Cup tray
9 Drip tray
10 Bottom cover
11

On/off switch

12 Steam tube & nozzle
13 Water tank
14 Measure scoop
EN
17