Herunterladen Inhalt Inhalt Diese Seite drucken

Installation; Mounting; Operation - EuroLite LED Snowfall Bedienungsanleitung

Effektröhre
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Do not shake the device. Avoid brute force when installing or operating the device.
When choosing the installation-spot, please make sure that the device is not exposed to extreme heat,
moisture or dust. There should not be any cables lying around. You endanger your own and the safety of
others!
Never use the device during thunderstorms. Over voltage could destroy the device. Always disconnect the
device during thunderstorms.
Operate the device only after having familiarized with its functions. Do not permit operation by persons not
qualified for operating the device. Most damages are the result of unprofessional operation!
Please use the original packaging if the device is to be transported.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, etc.

INSTALLATION

Mounting

The installation of the device has to be built and constructed in a way that it can hold 10 times the weight for
1 hour without any harming deformation.
Before rigging make sure that the installation area can hold a minimum point load of 10 times the device's
weight.
Do only use appropriate screws and make sure that the screws are properly connected with the ground.

Operation

Unpack the LED Snowfall Effect Tubes.
Remove the plastic wrapping from the tubes.
Install the tubes at the desired installation-spot.
Connect the connection cables with one another.
Connect the device to the mains with the transformer.
You must use one transformer every 10 LED Snowfall Effect Tubes.
If the LED Snowfall Effect Tube shows any kind of inner or outer damage, for example deep scratches,
splintered tube or cable/plug damage, then any further use is forbidden. If LED Snowfall Effect Tube shows
any kind of damage during use, then the stick must not be touched and must be disconnected from the
mains as well as unplugged from the mains socket. A damaged LED Snowfall Effect Tube must not be
repaired with tape or similar resources. It must be either disposed of according to local environmental
regulations or taken to a professional for repairs.
9/10
00030982.DOC

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis