Operating Determinations - EuroLite LED Snowfall Bedienungsanleitung

This device has left our premises in absolutely perfect condition. In order to maintain this condition and to
ensure a safe operation, it is absolutely necessary for the user to follow the safety instructions and warning
notes written in this user manual.
Important:
Damages caused by the disregard of this user manual are not subject to warranty. The dealer will
not accept liability for any resulting defects or problems.
Please make sure that there are no obvious transport damages. Should you notice any damages on the
power unit or on the casing, do not take the device into operation and immediately consult your local dealer.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it
on immediately. The arising condensation water might damage your device. Leave the device switched off
until it has reached room temperature.
This device falls under protection-class III. The device always has to be operated with an appropriate
transformer. Always plug in the power unit last.
Always disconnect from the mains, when the device is not in use or before cleaning it.
Please note that damages caused by manual modifications on the device or unauthorized operation by
unqualified persons are not subject to warranty.
Keep away children and amateurs from the device!
There are no serviceable parts inside the device. Maintenance and service operations are only to be carried
out by authorized dealers.

OPERATING DETERMINATIONS

This device is a lighting effect for creating decorative effects. This product is only allowed to be operated with
an alternating voltage of 230 V, 50 Hz (via enclosed power unit).
The device must only be operated with the included power unit. The power unit falls under protection-class 2
and the lighting effect under protection-class 3.
Lighting effects are not designed for permanent operation. Consistent operation breaks will ensure that the
device will serve you for a long time without defects.
This device is splash-proof (IP 44) and therefore qualified for indoor and outdoor use. In order to maintain
this protection grade after opening the housing, any rubber sealings must be examined for damages and
always be correctly installed.
For outdoor use, the installer must always make sure to connect a rubber cable H05R. For installations in the
ground, an underground power cable NYY must be used!
All valid instructions concerning the installation of cables outdoors or in the ground must be adhered!
The ambient temperature must always be between -25° C and +45° C. Keep away from direct insulation
(particularly in cars) and heaters.
The maximum relative humidity is 100 % with an ambient temperature of 25° C.
This device must only be operated in an altitude between -20 and 2000 m over NN.
- - -m
The symbol
between light-output and the illuminated surface must be more than 0.1 meters.
The maximum ambient temperature T
determines the minimum distance from lighted objects. The minimum distance
must never be exceeded.
a
8/10 00030982.DOC