Klarstein Orfeo Bedienungsanleitung Seite 16

EN
16
INSTRUCTIONS FOR USE
Follow these instructions carefully to avoid seriously damaging your barbecue and
causing injury to yourself and to property.
1. Assemble the barbecue following the assembly instructions carefully.
2. Connect the gas hose to the barbecue. Connect the regulator to the hose.
3. Connect the regulator to the cylinder valve following the regulator instructions
supplied with the regulator.
4. Turn all of the control knobs to the 'OFF' position before turning on the gas supply to
the appliance.
5. Operate the regulator in accordance with the instructions supplied with the
regulator.
Lighting your barbecue
Warning
Risk of fire
Before attempting to light your gas grill you must refer to your
lighting instructions and warning / safety points.
Check the hose before each use, searching for cracking, cuts or any
abrasions. If the hose is found to be faulty in any way do not attempt
to use your gas grill.
When changing your gas bottle, ensure that no sources of ignition,
such as fires, cigarettes, naked flames, etc., are in the area. Make
sure that the appliance is switched off.
1. Connect the gas cylinder to the barbecue following the instructions supplied with
the regulator.
2. Turn all the control knobs to the 'OFF' position.
3. Turn 'ON' the gas supply at the cylinder or regulator switch following the regulator
connection and operating instructions. With soapy water, check for any gas
leakage between the bottle and the regulator and the gas valve. Any leakage will
show as bubbles in the area of the leak. If leak is found do not use the barbecue.
Consult your gas or barbecue supplier for advice.
4. To light the left hand burner, push down the left hand control knob and keep
pressing while turning anticlockwise to the "full rate" position whilst press the
ignition button sited between the two knobs up to four times in rapid succession. This
will light the left hand burner. If not please repeat this process.
5. If the burner has not lit after two attempts, turn 'OFF' the gas tap and wait 5 minutes
before retrying the ignition sequence.
6. If the burner does not stay alight, please repeat step 4.
7. When the burner is lit. Adjust the heat by turning the knob to the High/Low position.
8. To light the right hand burner, push down the right hand control knob and keep
pressing whilst turning anti-clockwise to the "full rate" position whilst press the