Presetting Stations Manually; Storage When Not In Use; Cleaning; Troubleshooting - Silvercrest SST 100 A1 Bedienungs- Und Sicherheitshinweise

Tuning in a station
Press and hold the /
control, the frequency changes down or up
automatically until a station is found.
Note:
The search may not stop at a station with a very
weak signal.
Press the / buttons on the remote control
repeatedly until you find the station you want.
Each press of the /
frequency by 0.1 MHz. If reception is still poor, try
to move the radio to another location.

Presetting stations manually

You can preset up to 20 FM stations.
1. Tune in the desired station, then press the
PROG button on the remote control.
Press the PRE-/PRE+ buttons on the remote
2.
control to select the preset number.
Press the PROG button on the remote control
3.
to store the station.
4. Repeat above steps 1 to 3 for each station
you want to store in memory with a preset
number.

Storage when not in use

Store the unit in a dry location to protect it from
dust and direct sunlight.

Cleaning

• Switch the product off, remove all plugs before
cleaning!
• No acid, chafing or solvent cleaning agents
should be used or the product can be
damaged.
• Only clean the outside of the product using a
soft, dry cloth!
• For persistent soiling, a mild cleaning agent
can be used.
buttons on the remote
buttons will adjust the
• It is necessary to repair the product if it has
been damaged in any way, for example, if the
housing is damaged, if liquid or objects have
penetrated the device or if the product has
been exposed to rain or moisture.
• Repair work is also required if the device is
not working properly or has been dropped.
If smoke is produced, or there are any
unusual sounds or smells, turn the product off
immediately. In such cases, the product should
not be used until they have been inspected by
authorised service personnel. Only have the
device repaired by qualified personnel. Never
open the housing of the product.
• Only use a clean, dry cloth for cleaning the
product and never use any corrosive liquids.
Use a slightly moistened cloth and a mild
cleaning agent to remove stubborn dirt.

Troubleshooting

To keep the warranty valid, never try to repair the
system yourself. If you encounter problems when
using this unit, check the following points before
requesting service.
No power
• Ensure that the AC cord of the apparatus is
connected properly.
• Ensure that there is power at the AC outlet.
• Press the standby button to turn the unit on.
Remote control does not work
• Before you press any playback control button,
first select the correct source.
• Reduce the distance between the remote
control and the unit.
• Insert the battery with its polarities (+/-)
aligned correctly.
• Replace the battery.
• Aim the remote control directly at the sensor on
the front of the unit.
Clock setting erased
• Power has been interrupted or the power cord
has been disconnected.
• Reset the clock.
GB/IE 31