Inhaltsverzeichnis
Werbung
WARNING: This server is very heavy. To reduce the risk of personal injury or damage to the
equipment:
• Observe local occupational health and safety requirements and guidelines for manual
material handling.
• Get help to lift and stabilize the product during installation or removal, especially when the
product is not fastened to the rails. Hewlett Packard Enterprise recommends that a
minimum of two people are required for all rack server installations. A third person may be
required to help align the server if the server is installed higher than chest level.
• Use caution when installing the server in or removing the server from the rack; it is unstable
when not fastened to the rails.
Press the Power On/Standby button.
1.
The server powers down and enters standby mode. The system power LED changes from green to
amber. Power is still applied to the server.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Disconnect all peripheral cables and power cords from the rear panel.
3.
Remove the server from the rack (on page 16).
4.
Remove the access panel (on page 17).
5.
Remove the fan blank in a nonredundant configuration.
6.
Hardware options installation 44
Werbung
Inhaltsverzeichnis
