Mini-Sas Cable Option - Hewlett Packard Enterprise ProLiant DL360e Gen8 Bedienungsanleitung

CAUTION: To prevent improper cooling and thermal damage, do not operate the server
unless all bays are populated with either a component or a blank.
Power up the server (on page 15).
13.

Mini-SAS cable option

The Mini-SAS cables in this option kit support the following drive configurations:
Drive configuration
Four-bay LFF
Four-bay LFF
Eight-bay SFF
Eight-bay SFF
To connect the cable option:
Power down the server (on page 15).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 15).
o
Remove the server from the rack (on page 16).
o
Remove the access panel (on page 17).
4.
Remove the PCI riser cage (on page 18).
5.
Install the storage controller
6.
Connect the common end of the Mini-SAS cable to the controller option.
7.
Install the PCI riser cage (on page 18).
8.
Route the Mini-SAS cable along the side of the system board towards the front chassis, and then
9.
connect the cable to the drive backplane.
Connect the rest of the drive cables required in this drive configuration. For more information, see
10.
"Storage cabling (on page 65)."
In the four-bay LFF drive cage configuration, Hewlett Packard Enterprise recommends securing the
11.
excess length of the Mini-SAS cable by using the cable clip that came with the kit:
Use the two vertical dash marks in front of the fan cage to position the clip correctly, and then
a.
attach the cable clip.
HPE Smart Array RAID
Controller
H220 or P420
H222 or P222
P822
H220 or P420
("Installing a storage
Expansion slot Mini-SAS cable
Full height or low 800 mm
profile
Full height or low 890 mm
profile
615 mm and 800 mm
Full height
Low profile 615 mm and 800 mm
controller" on page 35).
Hardware options installation 32