Busch-Jaeger 6186/33 Produkthandbuch Seite 204

Busch-Installationsbus
Third party software components, notices
and OSS license texts
KERNEL_DIR
If this is not set it will default to /lib/modules/`uname -r`/build
This is used if USE_KLIBC=true to find the kernel include
directory that klibc needs to build against. This must be set
if you are not building udev while running a 2.6 kernel.
So, if you want to build udev using klibc with debugging messages, you
would do:
make USE_KLIBC=true DEBUG=true
- Install the project:
make install
This will put the udev binary in /sbin, create the /udev and /etc/udev
directories, and place the udev configuration files in /etc/udev. You
will probably want to edit the *.rules files to create custom naming
rules. More info on how the config files are set up are contained in
comments in the files, and is located in the documentation.
- Add and remove devices from the system and marvel as nodes are created
and removed in /udev/ based on the device types.
- If you later get sick of it, uninstall it:
make uninstall
202 2CDC502082D0101 | 6186/33
®
KNX