Busch-Jaeger 6186/33 Produkthandbuch Seite 203

Busch-Installationsbus
Third party software components, notices
and OSS license texts
- Build the project:
make
Note:
There are a number of different flags that you can use when building
udev. They are as follows:
prefix
set this to the default root that you want udev to be
installed into. This works just like the 'configure --prefix'
script does. Default value is ''. Only override this if you
really know what you are doing.
USE_KLIBC
if set to 'true', udev is built and linked against the
included version of klibc. Default value is 'false'.
USE_LOG
if set to 'true', udev will emit messages to the syslog when
it creates or removes device nodes. This is helpful to see
what udev is doing. This is enabled by default. Note, if you
are building udev against klibc it is recommended that you
disable this option (due to klibc's syslog implementation.)
USE_SELINUX
if set to 'true', udev will be built with SELinux support
enabled. This is disabled by default.
DEBUG
if set to 'true', debugging messages will be sent to the syslog
as udev is run. Default value is 'false'.
®
KNX
6186/33 | 2CDC502082D0101 201