Udev (V058) - Busch-Jaeger 6186/33 Produkthandbuch

Busch-Installationsbus
Third party software components, notices
and OSS license texts

Udev (v058):

udev - a userspace implementation of devfs
For more information on the design, and structure of this project, see the
files in the docs/ directory.
To use:
- You must be running a 2.6 version of the Linux kernel.
- Your 2.6 kernel must have had CONFIG_HOTPLUG enabled when it was built.
- Make sure sysfs is mounted. udev will figure out where sysfs is mounted, but
the traditional place for it is at /sys. You can mount it by hand by running:
mount -t sysfs none /sys
- Make sure you have the latest version of the linux-hotplug scripts. They are
available at linux-hotplug.sf.net or from your local kernel.org mirror at:
kernel.org/pub/linux/utils/kernel/hotplug/
They are required in order for udev to work properly.
If for some reason you do not install the hotplug scripts, you must tell the
kernel to point the hotplug binary at wherever you install udev at. This can
be done by:
echo "/sbin/udev" > /proc/sys/kernel/hotplug
200 2CDC502082D0101 | 6186/33
®
KNX